What do AWS IAM policies define?
AWS IAM policies define what an authenticated principal, such as a user or assumed role, may do to a resource.
Study 3 Policies and Permissions with 12 free online flashcards. Review key terms, definitions, and concepts with this interactive flashcard deck.
What do AWS IAM policies define?
AWS IAM policies define what an authenticated principal, such as a user or assumed role, may do to a resource.
What must be matched to evaluate an IAM access request?
Match the principal, requested action, target resource, and any relevant conditions against applicable policies.
What does the Effect field specify?
Effect specifies whether a statement is an Allow or a Deny.
What does the Action field identify?
Action identifies the AWS operation or operations covered by the statement, such as s3:GetObject.
What does the Resource field identify?
Resource identifies the resource ARN or ARNs to which the statement applies.
How does Principal differ between identity-based and resource-based policies?
Identity-based policies omit Principal because the attached identity is implied. Resource-based policies specify the principal they address.
What role does Condition play in an IAM statement?
Condition sets context requirements, such as a source IP address or a required tag, that must match the request.
How do S3 object reading and bucket listing differ in IAM?
Reading an object requires s3:GetObject on an object ARN. Listing a bucket requires the separate s3:ListBucket action, normally on the bucket ARN.
What happens when no applicable IAM Allow exists?
IAM starts with an implicit deny: if no applicable Allow exists, the request has no access.
How does an explicit Deny affect an applicable Allow?
An applicable explicit Deny overrides an Allow, so finding an Allow alone does not establish that access will succeed.
Do permissions boundaries, session policies, and SCPs grant access?
Permissions boundaries, session policies, and SCPs limit permissions; they do not grant permissions by themselves.
How can identity-based and resource-based policies affect same-account access?
For a same-account request, identity-based and resource-based policies can both contribute an Allow, subject to applicable limits and explicit denies.
A medium-difficulty quiz on how Layer 2 switches learn MAC addresses, forward and filter frames, and apply VLAN boundaries.
Practice interpreting routing-table entries and applying route selection and packet-forwarding rules, from basic route meanings to multi-step analysis.
Learn how routers read routing tables, select routes, and forward packets using destination prefixes, next hops, and outgoing interfaces.
Practice configuring, verifying, and troubleshooting IPv4 static routes, including route selection and administrative distance.
Learn how to configure, select, verify, and troubleshoot IPv4 static routes on Cisco IOS and IOS XE, including default and backup routes.
A medium-difficulty quiz on VLAN concepts, access-port configuration, verification, and troubleshooting.
A medium-difficulty quiz on configuring, verifying, and troubleshooting IEEE 802.1Q trunks.
A medium-difficulty quiz on route selection and troubleshooting, covering routing metrics, administrative distance, longest-prefix matching, route usability, and Cisco IOS diagnostic commands.
A medium-difficulty quiz on STP loop prevention, root and port selection, VLAN-specific operation, configuration, and troubleshooting.
Review how to diagnose common Layer 2 switching problems by tracing VLANs, trunks, spanning tree, and MAC learning end to end.
Apply Layer 2 troubleshooting checks to diagnose VLAN, trunk, MAC-learning, and spanning-tree behavior. Work from the evidence and select corrections that address the underlying cause without disrupting unrelated traffic.
A practical guide to tracing Layer 2 traffic, diagnosing VLAN and spanning-tree problems, and verifying repairs on switches.