Timedora

2 Transmission-Based Precautions

Learn how Transmission-Based Precautions supplement Standard Precautions, how Contact, Droplet, and Airborne measures differ, and how to apply them safely in patient care.

How the precautions work together

add measures when alone are not sufficient to prevent spread. Use them for patients with known or suspected infections or colonization, and always apply them alongside . Begin promptly based on symptoms and the likely infection, then adjust as more information becomes available. Some infections require more than one category.

apply to every patient in every care setting. They include hand hygiene, choosing based on anticipated exposure, , safe injection practices, and appropriate handling and cleaning of equipment and the environment. Transmission-specific measures do not replace these foundational practices.

The three transmission routes

The category selected depends on the likely route of spread. The examples below are illustrative, not a substitute for current disease-specific guidance. Required precautions and their duration vary by infection and clinical situation.

Contact

address spread through direct contact with a patient or indirect contact through contaminated hands, clothing, equipment, or nearby surfaces. Examples include scabies, draining wounds that cannot be contained, and some infections spread through secretions or contaminated surroundings.

Use a single room or designated space when available. Put on a gown and gloves before interactions likely to involve the patient or their environment, and remove contaminated PPE before leaving the room or space. Limit transport to medically necessary purposes; contain affected areas and use clean PPE at the destination. Dedicate equipment to the patient when feasible, or clean and disinfect shared equipment before another patient uses it.

Droplet

address infections spread through respiratory droplets produced when a person coughs, sneezes, or talks. These droplets can reach another person, especially the eyes, nose, or mouth at close range. Examples include influenza, pertussis, and meningococcal disease.

Place the patient in a single room when possible and wear a medical mask on room entry. Add gloves, a gown, and eye protection when indicate a risk of contact with secretions or splashes. Encourage and mask the patient for necessary transport when tolerated.

Airborne

address infections spread through particles that remain infectious while suspended in the air. Examples include pulmonary or laryngeal tuberculosis, measles, and chickenpox (varicella).

Use an when available, and wear a fit-tested, NIOSH-approved N95 or higher-level respirator when entering the room. If an AIIR is unavailable, guidance describes masking the patient and placing them in a private room with the door closed while arranging transfer or another appropriate plan. Limit transport; mask the patient when transport is necessary, if possible. A medical mask is not a substitute for a respirator when respiratory protection is required.

Applying precautions in practice

  1. Recognize risk early. Use symptoms and likely diagnoses—not only test results—to guide precautions at triage and during care. When feasible, place patients who may need precautions in a single-patient room or space while assessing them.

  2. Check instructions and local policy. Confirm the indicated category, PPE, room placement, transport steps, and when precautions can end. Consult current disease-specific guidance because the duration and combination of precautions differ by infection.

  3. Perform hand hygiene. Clean hands before patient contact and before aseptic tasks; after contact with the patient or their environment; after exposure to body fluids or contaminated surfaces; and immediately after glove removal. Use alcohol-based hand rub for most clinical situations unless hands are visibly soiled; then wash with soap and water. Gloves do not replace hand hygiene.

  4. Select PPE for the route and the task. Apply the transmission-specific minimum—for example, a gown and gloves for , a medical mask for , or a fit-tested respirator for . Add PPE required by anticipated exposure under . Follow facility procedures for putting on and removing PPE, and avoid touching contaminated surfaces or clothing during removal.

  5. Control movement and shared items. Limit transport to necessary trips, use source control such as patient masking when appropriate, communicate precautions to the receiving area, and clean or dedicate equipment as indicated.

For example, if a patient arrives with a cough and symptoms suggesting a transmissible respiratory infection, promptly apply , place the patient in an exam room or other suitable space, and use precautions based on the suspected illness while it is evaluated. If airborne infection is suspected, use an AIIR and a fit-tested respirator rather than relying on a medical mask alone.

Maintain safeguards throughout care

remain the baseline for all patient care. Add Contact, Droplet, and/or when the likely route of spread calls for additional controls. Match room placement, PPE, transport, equipment handling, and cleaning to the specific precaution and infection. Maintain hand hygiene throughout care, and follow current disease-specific and facility guidance for the exact precautions and their duration.