IV bags, tubing, and administration sets should be used for one patient only.
2 Intravenous Medication Administration Online Quiz Questions
Use this free practice quiz with 20 questions to review 2 Intravenous Medication Administration, test your knowledge, and prepare for your next test or exam.
If two IV solutions look clear when mixed, their appearance is enough to confirm that they are compatible.
- A
True
- B
False
A pump should be used when it is required by the medication order, the medication, or facility policy.
- A
True
- B
False
An order specifies an IV push over five minutes. How should you determine the preparation and administration method?
- A
Use the rate for a similar medication and prepare the dose without checking further.
- B
Follow the ordered five-minute duration while checking drug-specific and approved facility guidance for preparation and administration; seek clarification if they conflict or are unclear.
- C
Administer at any rate described as slow because the order gives a five-minute duration.
- D
Use the same dilution and rate used for the last IV push medication.
A medication is due through the same line as a running maintenance solution, but compatibility information is unavailable. What is the safest action?
- A
Administer the medication through the running line if both solutions look clear.
- B
Flush the line and administer the medication without checking compatibility.
- C
Pause and check a current approved compatibility resource or consult the pharmacist; do not administer them together until the plan is confirmed.
- D
Mix a small amount of the medication with the fluid and proceed if no immediate change is visible.
You return after an interruption to find an IV medication in an unlabeled syringe. What should you do?
- A
Administer it if you remember which medication you prepared.
- B
Discard it and prepare the medication again; label the new syringe as required by policy.
- C
Ask a coworker to guess what the syringe contains based on its appearance.
- D
Set it aside until you are confident you remember what is in it.
While checking an IV medication, you find that the dose calculation is unclear. What is the safest response?
- A
Estimate the value and proceed if it seems reasonable.
- B
Use the value from a previous patient’s order.
- C
Stop and seek clarification before proceeding.
- D
Proceed, then document that the calculation was uncertain.
Which actions are appropriate safety checks when preparing an IV medication? Select all that apply.
- A
Verify the patient, medication, dose, route, time, allergies, and relevant order details using required checks.
- B
Reuse a syringe and needle between patients if the medication is unchanged.
- C
Use aseptic technique and a clean medication-preparation area.
- D
Check the medication label, concentration, expiration or beyond-use date, and container integrity.
A patient is prescribed an IV push medication. Which actions are appropriate? Select all that apply.
- A
Confirm the prescribed dose, any required dilution, and administration rate using drug-specific and approved facility guidance.
- B
Infer the rate from the word “slow” if the medication instructions are not available.
- C
Assess the patient and vascular access before and after administration.
- D
Use a rate from another medication if its dose is similar.
- E
Monitor for adverse effects during and after administration.
An infusion of 1,000 mL is prescribed over 8 hr. What pump rate should be set?
The ordered dose is 750 mg. A vial contains 1,000 mg in 10 mL. What volume provides the ordered dose?
A gravity infusion is prescribed as 120 mL over 40 min using tubing calibrated at 15 drops/mL. Calculate the rate in drops per minute, show your calculation, and round to the nearest whole drop.
You are interrupted while preparing an IV medication and return to find an unlabeled syringe. What is the safest action?
- A
Administer it if you remember which medication you prepared.
- B
Ask another clinician to identify it by its appearance.
- C
Discard it and prepare the medication again.
- D
Label it with the medication you think it contains.
Before administering an IV medication, which set of checks best matches the required patient-identification and medication-check processes?
- A
Verify the medication name and dose only.
- B
Verify the patient, medication, dose, route, time, allergies, and relevant order details using required checks.
- C
Verify the patient and route only.
- D
Verify the medication, dose, and time, but check allergies only if a reaction is visible.
An IV medication is due through the same line as a running maintenance solution, but compatibility information is unavailable. What should you do?
- A
Use the shared line if the medication and fluid look clear.
- B
Flush the line and administer without checking compatibility.
- C
Assume compatibility if the fluid is commonly used for maintenance.
- D
Check a current, facility-approved compatibility resource or consult the pharmacist before administering through the shared line.
When should you assess the IV site and patient during medication administration?
- A
Assess the IV site and patient before, during, and after administration as appropriate to the medication and route.
- B
Assess the patient only after the medication is given.
- C
Assess the IV site before administration, but not during or afterward.
- D
Assess only if the patient reports discomfort.
The order is for 750 mg IV, and the vial contains 1,000 mg in 10 mL. What volume provides the ordered dose? Enter the value in mL.
An infusion order is for 1,000 mL over 8 hours. What pump rate should be set? Enter the value in mL/hr.
A nurse is preparing an IV medication before administration. To reduce contamination risk, use a and maintain .
A nurse needs to enter a medication container for another dose. For this entry, use a new and a new .