Dimensional Analysis for Infusion Rates
Learn to organize infusion calculations with units, use cancellation to check the setup, and connect dose, time, concentration, and the requested rate.
Track Units to Find and Check Infusion Rates
Let units guide the calculation
is both a method for finding an infusion rate and a way to catch setup errors. Write units beside every value, then arrange the factors so units you no longer need cancel. Before accepting the result, check that the units left over are the units requested. A correct-looking number with the wrong units signals that a conversion or factor may be missing.
Gravity tubing: drops per minute
Gravity tubing is adjusted by counting drops, so its rate is expressed in whole drops per minute (gtt/min). Use the drop factor printed on the tubing package; do not infer it from appearance. For 750 mL over 5 hours with tubing labeled 15 gtt/mL, convert the time to minutes: 5 hr × 60 min/hr = 300 min. Then calculate:
The mL and hr cancel, leaving the requested gtt/min. Following the applicable rounding policy, this example rounds to 38 gtt/min because gravity rates are set in whole drops. After setting the infusion, count drops over a full minute to verify the rate.
Pump: milliliters per hour
For a pump, divide the volume by time in hours. If time is given in minutes, include a conversion factor so minutes cancel. For 250 mL over 90 minutes:
The 60 min/hr factor converts the per-minute rate to a per-hour rate; the minutes cancel, leaving mL/hr. Enter the rate at the precision the pump supports and local policy requires. A programmed pump controls its rate, but that does not by itself establish that the medication, concentration, volume, or duration was selected correctly.
Dose and concentration: combine the conversions
For a dose-based order, first convert the dose to an amount per hour, then use the solution concentration to turn that amount into a volume per hour. In this hypothetical math example, the order is 5 mcg/kg/min for a 70 kg patient, and the solution contains 400 mg in 250 mL. The 70 kg cancels kg, and 60 min/hr changes the amount per minute to an amount per hour. Since 1 mg = 1000 mcg, use 1 mg/1000 mcg to convert micrograms to milligrams. Finally, multiply by 250 mL/400 mg, the volume per amount of drug:
The kg, min, mcg, and mg units cancel, leaving mL/hr. If the pump and applicable policy call for tenths, the rate is 13.1 mL/hr. This calculation is not a treatment recommendation. Actual orders, concentrations, and rounding must be checked against the prescription and clinical policy. In every case, unit cancellation checks the mathematics; verification against the order and applicable policy checks the setup.