Timedora
Free Online Flashcard Deck

Mechanical Properties of Materials Free Online Flashcards

Study Mechanical Properties of Materials with 12 free online flashcards. Review key terms, definitions, and concepts with this interactive flashcard deck.

12 cards
01
Front

How do the proportional limit and elastic limit differ?

Back

The proportional limit ends proportional stress–strain behavior. The elastic limit is the greatest stress from which the material can still fully recover; the two limits need not coincide.

02
Front

What is engineering normal strain?

Back

Engineering normal strain is change in length divided by original length: εeng=L−L0L0=δL0\varepsilon_{\text{eng}}=\frac{L-L_0}{L_0}=\frac{\delta}{L_0}. It is dimensionless.

03
Front

How is a uniform, linearly elastic bar’s axial deformation calculated?

Back

For a prismatic bar with uniform properties under axial force in the linear-elastic range, the change in length is δ=PLAE\delta=\frac{PL}{AE}. Greater force or length increases deformation; greater area or stiffness reduces it.

04
Front

Which elastic constants measure resistance to axial and shear deformation?

Back

Young’s modulus EE measures resistance to axial extension or compression; shear modulus GG measures resistance to shear distortion.

05
Front

How are average normal and shear stress calculated?

Back

Average normal stress is σavg=PA\sigma_{\text{avg}}=\frac{P}{A}, and average shear stress is τavg=VA\tau_{\text{avg}}=\frac{V}{A}, where PP is axial force and VV is shear force.

06
Front

How does true strain differ from engineering strain?

Back

For uniform uniaxial deformation, true strain accounts for successive length changes: εtrue=ln⁡(LL0)\varepsilon_{\text{true}}=\ln\left(\frac{L}{L_0}\right). Engineering strain instead divides total length change by original length.

07
Front

What does Poisson’s ratio describe?

Back

Poisson’s ratio is the negative ratio of lateral strain to axial strain: ν=−εlatεaxial\nu=-\frac{\varepsilon_{\text{lat}}}{\varepsilon_{\text{axial}}}. A stretched specimen usually contracts laterally.

08
Front

How do area and elastic modulus affect axial deformation?

Back

For a prismatic bar in the linear-elastic range, δ=PLAE\delta=\frac{PL}{AE}. Deformation decreases as cross-sectional area AA or elastic modulus EE increases, with the other quantities fixed.

09
Front

What is the typical progression of a ductile material in tension?

Back

A typical ductile-material tensile curve progresses from linear elasticity to yielding, plastic deformation, and strain hardening. Engineering stress may then fall during necking before fracture.

10
Front

How do normal and shear stress differ in direction?

Back

Normal stress acts perpendicular to a section; shear stress acts tangent to it. Both are internal force per unit area and are measured in pascals.

11
Front

What remains after unloading beyond the elastic limit?

Back

Beyond the elastic limit, unloading does not restore the material fully to its original shape; permanent plastic deformation remains.

12
Front

What limitation applies to average-stress formulas?

Back

The formulas σavg=PA\sigma_{\text{avg}}=\frac{P}{A} and τavg=VA\tau_{\text{avg}}=\frac{V}{A} give average stress. Local stress can vary across a section, especially near load application points or in complex geometries.