Timedora
Free Online Flashcard Deck

Watershed Hydrology and Streamflow Free Online Flashcards

Study Watershed Hydrology and Streamflow with 12 free online flashcards. Review key terms, definitions, and concepts with this interactive flashcard deck.

12 cards
01
Front

How are watershed models evaluated against observed conditions?

Back

Hydrologic models represent processes such as infiltration, runoff, subsurface flow, and channel routing. Comparing model results with observed rainfall and streamflow helps evaluate whether the model represents the watershed adequately.

02
Front

How do gauges, radar, and a hyetograph describe watershed rainfall?

Back

Rain gauges provide direct measurements at points, while radar estimates rainfall over a broad area. Combining both helps estimate rainfall distribution across a watershed; a hyetograph shows rainfall depth over time.

03
Front

What does lag time measure on a watershed hydrograph?

Back

Lag time is the delay between rainfall and peak flow. On a discharge hydrograph, the peak marks the maximum discharge.

04
Front

What gross volume falls on a 3-square-mile basin under 2 inches of rain?

Back

The gross precipitation volume is about 13,939,200 cubic feet. This is not runoff volume because some water is intercepted, infiltrates, evaporates, or remains in storage.

05
Front

What is the watershed water-budget equation?

Back

Over a chosen interval, precipitation plus inflow equals evapotranspiration plus change in storage plus outflow: P+Qin=ET+ΔS+QoutP + Q_{in} = ET + \Delta S + Q_{out}.

06
Front

What does the Rational Method estimate, and what does it not provide?

Back

For a small drainage basin, the Rational Method estimates peak flow with Q=C×i×AQ = C \times i \times A. It estimates peak flow, not a complete hydrograph or runoff volume.

07
Front

Why should watershed flow estimates be interpreted with caution?

Back

Interpret estimates in light of their inputs, assumptions, and uncertainty. Rainfall varies across a watershed, channels can change, and model results depend on data and assumptions.

08
Front

How are channel area and average velocity used to estimate discharge?

Back

Discharge is the volume of water passing a channel cross section per unit time. Estimate it with Q=A×VQ = A \times V, where AA is cross-sectional area and VV is average velocity.

09
Front

How does a rating curve turn streamgage stage into discharge?

Back

A site-specific stage–discharge rating curve converts streamgage stage—the water-surface height relative to a local reference level—into estimated discharge.

10
Front

What do the rising limb, peak, and recession limb show?

Back

The rising limb follows increasing flow; the peak is maximum discharge; and the recession limb shows flow declining after the peak.

11
Front

Why must a streamgage rating curve be checked and updated?

Back

Check and update a rating curve because floods, sediment movement, vegetation, ice, or construction can alter the channel and its stage–discharge relationship.

12
Front

What does a unit-hydrograph approach represent?

Back

A unit-hydrograph approach represents how a watershed transforms a specified amount of excess rainfall into a discharge response that changes over time.