Timedora
Free Practice Quiz Question List

7 Type II Certification Practice Online Quiz Questions

Use this free practice quiz with 20 questions to review 7 Type II Certification Practice, test your knowledge, and prepare for your next test or exam.

20 questions
01
True or false
1 point

True or false: A pressure check that suggests a system is leaking is, by itself, a leak inspection.

  1. A

    True

  2. B

    False

02
True or false
1 point

True or false: The Section 608 leak-repair thresholds described here automatically apply to every appliance, regardless of the refrigerant it contains.

  1. A

    True

  2. B

    False

03
Choose one
1 point

Which task generally requires Section 608 certification because it could compromise an appliance’s refrigerant circuit?

  1. A

    Reading a room thermostat without opening the refrigerant circuit

  2. B

    Connecting gauges to measure appliance pressure

  3. C

    Replacing a filter in an unrelated air-cleaning device

04
Written response
1 point

What annual leak-rate trigger is listed for commercial refrigeration appliances subject to these Section 608 leak-repair requirements?

05
Fill in the blank
1 point

Owners or operators generally must repair a qualifying leak or develop a retrofit or retirement plan within days.

06
Choose one
1 point

A technician uses recovery equipment manufactured in 1992. Which statement best describes the equipment-certification rule in the material?

  1. A

    It must be certified because all recovery or recycling equipment is subject to the certification requirement.

  2. B

    It is prohibited from use because it predates the certification requirement.

  3. C

    It falls within the stated exception for equipment manufactured before November 15, 1993.

07
Written response
1 point

What is the full calendar date that separates the two recovery-equipment manufacture-date columns in the evacuation table?

08
Choose one
1 point

A high-pressure appliance has a full charge of 250 pounds. What evacuation level applies when the recovery equipment was manufactured on or after November 15, 1993?

  1. A

    0 inches of mercury vacuum

  2. B

    4 inches of mercury vacuum

  3. C

    10 inches of mercury vacuum

09
Fill in the blank
1 point

For a very-high-pressure appliance, the evacuation table specifies regardless of the recovery or recycling equipment’s manufacture date.

10
Choose all
1 point

Which statements about recovered refrigerant are supported by the material? Select all that apply.

  1. A

    It may generally be returned to the same appliance or another appliance owned by the same person.

  2. B

    It may be transferred to a different owner for reuse without reclamation if it was recovered as a liquid.

  3. C

    If it changes ownership, an EPA-certified reclaimer must reclaim it before transfer for reuse.

  4. D

    It must always be reclaimed before it can be returned to the same appliance.

11
Choose all
1 point

A leak prevents an appliance from reaching its normal evacuation level. Which actions or limits are consistent with the leak-related exception? Select all that apply.

  1. A

    Isolate leaking components from non-leaking components where possible.

  2. B

    Evacuate non-leaking portions to the specified level.

  3. C

    Evacuate leaking portions to the lowest achievable level without substantially contaminating the recovered refrigerant, but not above 0 psig.

  4. D

    Vent refrigerant from the leaking portion if the normal evacuation level cannot be reached.

12
Choose one
1 point

After the required evacuation level is reached and pressure is allowed to stabilize, what can a pressure rise indicate?

  1. A

    It proves the system has no remaining refrigerant.

  2. B

    It can indicate that refrigerant remains in the system or oil.

  3. C

    It means the appliance’s leak rate has been established.

13
True or false
1 point

True or false: If the evacuation table requires 0 inches of mercury vacuum, a technician may open the appliance while it is still positively pressurized.

  1. A

    True

  2. B

    False

14
Open ended
1 point

For an appliance subject to leak-repair rules, explain how a leak inspection differs from the initial verification test and the follow-up verification test.

15
Choose one
1 point

Which task generally requires Section 608 certification because it could compromise the refrigerant circuit?

  1. A

    Reading a room thermostat without opening the refrigerant circuit

  2. B

    Connecting gauges to measure an appliance’s pressure

  3. C

    Replacing a filter in an unrelated air-cleaning device

16
Choose one
1 point

A technician performs a pressure check that suggests an appliance is leaking. Which statement best describes what the check establishes?

  1. A

    It locates the leak because it shows that pressure is changing.

  2. B

    It is a leak inspection whenever the appliance contains refrigerant.

  3. C

    It may indicate a leak, but it does not by itself locate the leak.

  4. D

    It counts as a follow-up verification test under normal operating conditions.

17
Choose one
1 point

Which circumstance is an exception to the certification requirement for recovery or recycling equipment used for these Section 608 requirements?

  1. A

    The equipment was manufactured before November 15, 1993.

  2. B

    The equipment is used only on an appliance with a charge under 200 pounds.

  3. C

    The technician has previously used the equipment successfully.

  4. D

    The refrigerant will be returned to the same appliance.

18
Written response
1 point

What minimum charge of ozone-depleting refrigerant is covered by the general Section 608 leak-repair requirements, when the applicable annual leak-rate trigger is exceeded? Enter the charge in pounds.

19
Choose one
1 point

A technician recovers refrigerant that the owner wants to transfer to a different owner for reuse. What must happen before the transfer?

  1. A

    It may be transferred for reuse as long as the receiving owner uses certified recovery equipment.

  2. B

    It must be reclaimed by an EPA-certified reclaimer before transfer for reuse.

  3. C

    It may be transferred without reclamation if it came from a high-pressure appliance.

  4. D

    It must always be reclaimed before it can be returned to the same appliance.

20
Written response
1 point

Under the limited leak-related evacuation exception, what is the maximum pressure allowed in a leaking portion? Enter the numerical value in psig.