Timedora
Free Online Flashcard Deck

Retaining-Wall Design and Earth Pressure Free Online Flashcards

Study Retaining-Wall Design and Earth Pressure with 12 free online flashcards. Review key terms, definitions, and concepts with this interactive flashcard deck.

12 cards
01
Front

What geotechnical and structural checks are typical for retaining walls?

Back

Geotechnical checks include sliding, overturning, bearing resistance, settlement, and global stability. Structural checks cover bending, shear, and connections; reinforced systems also require reinforcement-strength and pullout checks.

02
Front

Under uniform-soil, no-water, no-surcharge conditions, what are the active resultant and its location?

Back

For uniform cohesionless soil with no groundwater or surcharge, Pa=12KaγH2P_a=\frac{1}{2}K_a\gamma H^2, acting H3\frac{H}{3} above the base.

03
Front

How do wall movements distinguish at-rest, active, and passive pressure states?

Back

At-rest pressure occurs when lateral soil strain is restrained; active pressure develops as the wall moves away from the soil; passive resistance develops as the wall pushes into it.

04
Front

Under Rankine conditions, how are KaK_a and KpK_p calculated?

Back

For level, cohesionless backfill against a smooth vertical wall, Ka=tan⁡2(45∘−ϕ′2)K_a=\tan^2(45^\circ-\frac{\phi'}{2}) and Kp=tan⁡2(45∘+ϕ′2)K_p=\tan^2(45^\circ+\frac{\phi'}{2}).

05
Front

Why may a triangular active-pressure diagram not fit an anchored wall?

Back

Pressure depends on wall and soil stiffness, soil strength, interface friction, and construction sequence. For anchored walls, a simple triangular active-pressure diagram may not represent the actual distribution.

06
Front

How do mechanically stabilized earth walls differ from soil-nailed walls?

Back

Mechanically stabilized earth walls reinforce compacted fill to create a stable reinforced-soil mass. Soil-nailed walls reinforce the ground in place, often as excavation proceeds in stages.

07
Front

How is total lateral pressure calculated below the water table?

Back

Below the water table, calculate effective soil pressure using γ′=γsat−γw\gamma'=\gamma_{sat}-\gamma_w, then add hydrostatic pressure u=γwzwu=\gamma_w z_w.

08
Front

What lateral load does a uniform surface surcharge add over wall height HH?

Back

A uniform surcharge qq adds approximately uniform lateral pressure KqKq over the wall height, with resultant KqHKqH.

09
Front

How do gravity walls and cantilever walls obtain stability?

Back

Gravity walls rely mainly on their mass for stability. Cantilever walls commonly use reinforced-concrete stems and bases to resist bending and shear.

10
Front

Which checks address both retaining-wall stability and structural capacity?

Back

Check sliding, overturning, bearing resistance, settlement, and global soil stability. Also check structural bending, shear, and connections, plus reinforcement strength and pullout in reinforced systems.

11
Front

How do embedded retaining walls gain support?

Back

Embedded walls, such as sheet-pile or soldier-pile walls, gain support from soil below excavation level and may be cantilevered or braced with anchors or struts.

12
Front

Which expressions give submerged unit weight and hydrostatic pressure below the water table?

Back

Use submerged unit weight γ′=γsat−γw\gamma'=\gamma_{sat}-\gamma_w for vertical effective stress, and calculate hydrostatic pressure as u=γwzwu=\gamma_w z_w, where zwz_w is depth below the water surface.